Jenway 73 Series PC software - Manual (Page 45)

45
6.1.8 Auto Logging
Auto logging allows repeat
measurements of the same sample
to be performed with a set time
interval between each measurement.
Use the arrow icons to increase or
decrease the time interval between
sample measurements and use the
arrow icons to select the number of
readings required. If auto logging is
not required the values do not need
to be adjusted in this screen.
6.2 CREATE CURVE
To create a new quantitation curve
first select the wavelength, in the
Settings screen, that the standards
and unknown samples are to be
measured at. Click on Create Curve
on the toolbar at the top of the page
tab.
Select the number of standards
which are going to be measured and
enter the concentration values of
these standards. If the absorbance
values of the standards are known
these can also be entered.