KROHNE OPTISONIC 6300 P-6400 EN - Manual (Page 32)

3
INSTALLATION FOR FLOW MEASUREMENT
32
OPTISONIC 6300 P
www.krohne.com 03/2013 - 4000972603 - MA OPTISONIC 6300 P R03 en
• In menu 1.12, press Next .
• Press Next .
• Enter a file name.
• Select Save site file .
3.6 Step 5: start flow measurement
Press "" on the converter. The converter checks the received signal and initiates the flow
measurement mode.
The display will show the actual flow now.
1.19
Sensor 1 status
Signal quality
Installed
80 %
< Previous | Next > 
13-04-2010 14:11:09 13 MB free
1.20
Site name Site name Site name Site name    
Cancel
Skip saving
Save site file
test test test test
13-04-2010 14:11:09 13 MB free
INFORMATION!
You can save the settings in a site file, so they can be used again later when measuring at the
same site (location).
Measurement
Site name
Display measurement Display measurement Display measurement Display measurement    
Load site
Save current site
Setup
test
13-04-2010 14:11:09 13 MB free
INFORMATION!
The device is now ready to measure.