Thermo Fisher Scientific Alpha COND 2000 (In the process of updating the brand guideline & product image) - Manual (Page 8)

Instruction Manual
αlpha CON 2000
2
1.3 Safety intsructions
The αlpha CON 2000 should be installed and operated only by personnel familiar with
the transmitter and who are qualified for such work.
A defective transmitter must neither be installed nor put into service.
The αlpha CON 2000 must only be operated under the specified operating conditions
(see section 8).
The
αlpha CON 2000 must not be repaired by the customer.
The αlpha CON 2000 must only be opened to replace the unit fuse or to set the
jumper for Pt100/Pt1000 temperature sensor. This work must be carried out only by
personnel familiar with the transmitter and who are qualified for such work. Make sure
the mains cable is separated from the power supply before opening the unit.
No modifications to the αlpha CON 2000 are allowed. The manufacturer/supplier
accepts no responsibility for damage caused by unauthorised modifications. The risk
is borne entirely by the user.
1.4 Putting out of service / Correct disposal of the unit
Putting out of service
• First disconnect the unit from the mains, then undo all electrical connections.
• Remove the unit from the wall / panel.
Correct disposal of the unit
When the transmitter is finally taken out of service, observe the local environmental
regulations for correct disposal or send the transmitter to your local Eutech Instruments
distributor, they will take care of proper disposal.