West Control Solutions SG 45 - Manual (Page 24)

6.2 Input scaling
Scaling of input values is possible. This correction influences the measured value after an eventually executed
linearization.
g
Specification of the input value of the lower and upper scaling point is in units of the relevant physical
quantity.
g
The Parameters InL, OuL, InH and OuH are always visible. These are created during calibration.
Parameters InL and InH determine the input range.
Example with %:
InL= 4 and InH = 10 means that measuring from 4 to 10 % is required.
+
For resetting the input scaling, the settings for InL and OuL as well as InH and OuH must
correspond.
Functions
SG 45 Input scaling 24
mA/V
phys.
quantity
mA / V phys. quantity
OuH.x
OuL.x
InH.x InL.x
Example for %