West Control Solutions SG 45 - Manual (Page 39)

7.3 Configurations
Dependent on device version und adjusted configurations values not needed become hidden.
µ Entrys marked with this symbol are selectable only with existing device-option.
Selection of functions Func
Name Value range Description
Fnc1 Function 1
0 No function
1 Zero setting
Fnc.2 Function 2
0 No function
3 Tare
Fnc.3 Function 3
0 No function
2 Sample & Hold
3 Integrator
Input INP
Name Value range Description
S.tYp Sensor type
60 0,5 mV/V
61 1 mV/V
62 2 mV/V
63 4 mV/V (the selection for sensors with 3,33mV/V)
S.Lin Linearization
0 No linearization
1 Special linearization
In.F Alternative value
Limit values Lim1 … Lim3
Name Value range Description
Fnc.1
(Fnc.2)
(Fnc.3)
Function of limit 1 (2, 3)
0 Switched off
1 Measurement value
2 Measured value monitoring + alarm status latch. A stored limit value can be reset
via error list or a digital input (
® LOGI/ Err.r).
3 Signal change (in minutes).
4 Signal monitoring for rate of change (per minute) + storage of the alarm status. A sto-
red limit value can be reset via error list or a digital input (
® LOGI/ Err.r).
Src.1
(Src.2)
(Src.3)
Source of limit 1 (2, 3)
0 process value = displayed value
3 Measured value INP
12 Zero offset (difference between the calibrated zero and the value at the time of
zero setting)
C.Std OFF; 1 …
9999999
Control operating hours (only visible with BlueControl
Ò
!)
C.Sch OFF; 1 …
9999999
Control switching cycles (only visible with BlueControl
Ò
!)
Configuration level
39 Configurations SG 45