Asante Technologies 6200 - Manual (Page 31)

Installation
Page 2-6
Connecting
Power
To connect power to the IntraSwitch:
▲
Important! Carefully review the power
requirements on page 2-2 before connecting
power to the IntraSwitch.
1 Plug one end of the supplied power cord into
the power connector on the back of the unit.
2 Plug the other end into a grounded AC outlet.
3 The front panel LEDs blink and the Power LED
illuminates.
▲
Important! If the power does not come
on, refer to Appendix A, “Troubleshooting.”
The unit is ready for connection to the network.
Connecting to
the Network
The IntraSwitch unit may be connected to an Ethernet
network, with the unit powered either on or off.
1 Connect network devices to the IntraSwitch, fol-
lowing the cable guidelines outlined below.
2 After the unit is connected to the network, it
can be configured for management capabilities.
See “Configuring for Management” on page 2-8.
10/100 Ports
Cabling Procedures
The 16 fixed 10/100 ports allow for the connection of 10Base-T
or 100Base-TX network devices. The ports are compatible with
IEEE 802.3 and 802.3u standards.
▲
Important! The IntraSwitch must be located
within 100 meters of its attached 10Base-T or
100Base-TX devices.
6216M Book Page 6 Wednesday, January 27, 1999 5:26 PM