Asante Technologies 6200 - Manual (Page 35)

Installation
Page 2-10
1 Using a straight-through RS-232 cable with a 9-
pin male D-subminiature plug at one end, con-
nect a terminal or workstation (PC or Macintosh)
running a terminal emulator to the
Console port
on the front of the IntraSwitch.
2 Make sure both units are powered on.
If using a PC with a terminal emulator, make
sure it is configured with the following terminal
settings:
❏ Baud: 9600
❏ Data Bits: 8
❏ Parity: None
❏ Stop Bits: 1
❏ Flow Control: None
3 Once connected, the Local Management Main
Menu appears on the terminal screen, as shown
in Figure 2-3.
Figure 2-3 Local Management Interface Main Menu
4 Type c to open the Configuration Menu.
The “Enter Password” prompt appears.
5 Type your password at the prompt.
▲
Important! The default password is
Asante
. The password is case-sensitive.
6216M Book Page 10 Wednesday, January 27, 1999 5:26 PM