NORD Drivesystems BU0240 User Manual
Page 18
NORDAC SK 200E Manual
18
BU
0240
GB
3 SK 200E displays and control
By combining different modules for display, control and parameterisation, the NORDAC SK 200E can be
easily adapted to various requirements.
Alphanumeric display and control modules (Illustration below) can be used for simple commissioning. For
more complex tasks, connection to a PC system and the use of Nord Con parameterisation software is
available.
As supplied, without additional options, the diagnostic LEDs are externally visible. These signal the actual
device status. 2 potentiometers and 8 DIP switches are provided in order to set the most important
parameters. In this minimal configuration no other adapted parameters are stored in the plug-in EEPROM.
The only exception is the data concerning operating hours, faults and fault circumstances. This data can be
stored in the EEPROM.
SK 200E mounted on motor, top view
SK 200E not fitted, view from inside
RJ12
LEDs
Potentiometers
Plug-in EEPROM
Æ
8x DIP switches
Æ
.
Parameterisation and display options: SK CSX-3H and SK PAR-3H