Transmille 1000-Series - Manual (Page 36)

1000 SERIES OPERATION MANUAL
TRANSMILLE LTD. Version 1.30 Page 36
Setting a DC Voltage Output
Complete the following procedure to set a dc voltage output. The and keys
can be used to edit the entry in the event of an incorrect key press.
Warning
ENSURE THE OUTPUT DOES NOT EXCEED RATING FOR UUT INPUT
1) Ensure the calibrator’s output has been set to Standby. This can be verified
by ensuring that standby is indicated on the display, and the output standby
status LED is lit.
2) Connect the UUT to the calibrator as described for DC Voltage
measurements (see connection diagram on Page 29)
3) Select the correct range on the UUT.
4) Press
5) Press the numeric and decimal point keys to enter the required value, e.g.
56.789.
6) Press key, depending upon the polarity of the output required (default is
positive)
7) Press the multiplier key (if required) e.g.
8) Press
9) The display will now indicate the value that has been entered below the
currently set output.