Transmille 1000-Series - Manual (Page 76)

1000 SERIES OPERATION MANUAL
TRANSMILLE LTD. Version 1.30 Page 76
AC Voltage Commands
Function Range Command
AC Voltage 100mV R12
1V R13
10V R14
100V R15
1000V R16
Standby Mode
Standby ON S1
Standby OFF S0
Output
Set Output O (not zero)
AC Frequency
Fxxxxx E.G. 10kHz = F10000
The AC voltage section consists of a set of range commands which are used in
conjunction with the standby and output command. To enable an AC Voltage to be
set and an output assigned, the following command sequence should be used :
<RANGE>/<OUTPUT>/<FREQUENCY>/<STANDBY CONDITION><CR>
For example, to get 1V @ 200Hz AC with the output switched on, the command is:
R13/O1/F200/S0<CR>
R13 = 1V Range (as detailed in the table above)
O1 = 1V Output
F200 = 200Hz Frequency
S0 = Standby OFF (i.e. output switched ON)
<CR> = Carriage Return (ASCII character 13)