Transmille 1000-Series - Manual (Page 71)

1000 SERIES OPERATION MANUAL
TRANSMILLE LTD. Version 1.30 Page 71
Remote Programming
WARNING
The 1000 series calibrators can produce high voltages up to 1025V
and must be programmed with due caution to prevent dangerous
voltages from being present at the output terminals without
warning to the operator.
Any programs should be extensively tested to maintain safe
operation and include safeguard’s such as error catchments and
handling to ensure that any commands sent to the calibrator
perform as expected and any that do not are safely handled to
ensure user safety.
Within the 1000 series command language, response codes are
included to determine the operational state of the calibrator. These
response codes can also be used to determine whether a
command was received correctly and thus ensuring safe operation
of the calibrator.
USB Interface
The calibrator can be fully controlled and calibrated via USB interface. The interface
is optically isolated from the calibrator circuitry. The calibrator can send information
with reference to the output status, calibration factors and value of internal
standards together with other information. The internal processor decodes the
commands and returns control codes to verify the correct operation of that
command.
The calibrator can be sent individual commands directly from a Windows HYPER
TERMINAL program, any basic or high level program or from the ProCal Calibration
System.