Adaptec SATA AND SCSI RAID CONTROLLERS - Manual (Page 108)

D-5
Command Line Interface
From the NetWare server console
To access the CLI from the NetWare server console, type aaccli at
the prompt. When the system displays the CLI> prompt, which
indicates that you can now use CLI commands.
Using the CLI
This section contains some examples of using CLI commands to
perform common tasks.
Opening and Closing a Controller
To prepare a controller to receive a CLI command, you first need to
open the controller. You may open only one controller at any time.
To open controller AAC0 and prepare it to receive more CLI
commands, type:
CLI> open AAC0
The prompt changes to reflect the open controller, as shown in the
next example. When you have finished with the controller, close it
by typing:
AAC0> close
Displaying Information about Your Disks
Before creating any array, use the disk show space command to
display information about your disks.
Note: Before you can create arrays, you need to initialize the
member drives.
In the following example, the Usage column indicates Free for each
disk, which means that the space on each disk consists of available
space.
AAC0> disk show space
Executing: disk show space
Scsi C:ID:L Usage
Size
----------- ---------- -------------
0:01:0 Free 64.0KB:8.47GB
0:02:0 Free 64.0KB:8.47GB
0:03:0 Free 64.0KB:8.47GB
0:04:0 Free 64.0KB:8.47GB