Adaptec SATA AND SCSI RAID CONTROLLERS - Manual (Page 75)

A-13
Adaptec RAID Configuration Utility (ARC)
SCSI Configuration Options
To access the SCSI Device Configuration options, select SCSI
Configuration
.
SCSI Channel Interface Definitions
The SCSI Channel Interface Definitions are described in the table
below.
Option Default Description
Controller SCSI
Channel ID 7 Sets the controller’s SCSI ID. Adaptec
recommends that you leave the controller set
to the default, which gives it the highest
priority on the SCSI channel.
SCSI Parity
Checking Enabled Determines whether the controller verifies
the accuracy of data transfer on the SCSI
channel. You should disable SCSI Parity
Checking on the controller and all SCSI
devices if any SCSI device supported by the
controller does not support SCSI parity;
otherwise, retain the default. Most SCSI
devices do support SCSI parity. If you are not
sure whether a device supports SCSI parity,
consult the documentation for the device.
Controller SCSI
Channel
Termination Auto
Mode Sets termination on the controller. Adaptec
recommends that you retain the default
setting.