HP NonStop G-Series - Manual (Page 110)

SCSI Request Sense
N1524A ACL Installation and User’s Guide for the NonStop S-Series Tape Enclosure — 527340-001
B- 6
Allocation Length
FRU Code
The Field Replaceable Unit (FRU) Code field is not used and shall always return a
value of zero.
SKSV
The Sense Key Specific Valid bit, when set to zero, specifies that bytes 15-17 are not
defined. If the sense key is ILLEGAL REQUEST and the SKSV bit is set to one, bytes
15-17 describe the parameter in error.
C/D
When set, indicates that the illegal parameter is in the CDB. A C/D of zero indicates
that the illegal parameter is in the parameter list from the initiator.
BPV
When the Bit Pointer Valid bit is set, it indicates that the bit pointer field is valid and
designates which bit of the byte designated by the field pointer is in error. For a multi-
bit field, it points to the most significant bit of the field.
Field Pointer
Indicates which byte of the CDB or parameter list was in error. For a multi byte field,
the most significant byte is indicated.
FSC
The fault symptom code (FSC) field contains the two byte fault symptom code reported
by the device.
47h 00h SCSI PARITY ERROR
48h 00h INITIATOR DETECTED ERROR
4Eh 00h OVERLAPPED COMMANDS ATTEMPTED
53h 00h MEDIA LOAD OR EJECT FAILED
53h 02h MEDIUM REMOVAL PREVENTED
80h 03h MEDIUM SOURCE ELEMENT NOT INSTALLED
80h 04h MEDIUM DESTINATION ELEMENT NOT INSTALLED
83h 01h ERROR READING BARCODE LABEL
83h 02h CARTRIDGE MAGAZINE IS NOT INSTALLED
83h 04h TAPE DRIVE IS NOT INSTALLED
83h 09h NO BARCODE LABEL DETECTED
83h 10h ELEMENT IS IN ERROR
ASC ASCQ Description