HP NonStop G-Series - Manual (Page 119)

Error Recovery Procedures and Fault Symptom
Codes
N1524A ACL Installation and User’s Guide for the NonStop S-Series Tape Enclosure — 527340-001
C- 7
Motor Process Error Codes (3xxx)
Motor Process Error Codes (3xxx)
2073 Drive Config Error Set if the Alternate Unload has not been selected. A, 3
2074 Stow Error A stow timeout error has occurred when
accessing a remote unit. Press Enter to Reboot
for orphan cartridge recovery. D, #
2075 Fetch Error During a remote fetch operation, the remote unit
returned an error. D, #
FSC Message Description ERP
3001 Picker Retries Exceeded Remove from code. A, B, 1, #
3002 Picker Tach Errors TACH errors were detected during a picker
movement. A, B, 2, 1,
#
3003 Elevator Tach Errors TACH errors were detected during an elevator
movement. A, B, 2, 1,
#
3004 Elevator Init Error An elevator jam was detected during initialization. A, B, 2, 1,
#
3006 Passthru Tach Errors TACH errors were detected during pass-thru
elevator movement. A, B, 4, 1,
#
3007 LTO Timeout Error Communication with one of the LTO drives was
unsuccessful. A command was issued but status
was not returned. A, B, 3, 1
3008 Invalid Drive State Currently unused A, B, 1
3009 Door Tach Errors TACH errors were detected during a door
movement. A, B, 15, 1
300A Door Fault During initialization, the door was found to be in
an improper state. A, B, 15, 1
300B Elev Open Tach Open Tach detected on elevator motor. A, B, 2, 1,
#
300C Picker Open Tach Open Tach detected on picker motor. A, B, 2, 1,
#
300D Door Open Tach Open Tach detected on door motor. A, B, 15, 1
300E Drive Stow Error A problem was encountered while trying to stow a
cartridge to a drive. Couldn't close the door. A, B, 9, 2,
3, #
300F Slave Init Error The slave module could not complete the elevator
initialization. This error will occur if the unit is
configured for slave mode, but the passthrough
cover plate has not been removed from the unit. A, B,
3010 Picker Retries Exceeded While attempting to fetch a cartridge, the picker
was not able position properly within 16 attempts. A, B, 2, 7,
#
FSC Message Description ERP