HP NonStop G-Series User Manual
Page 123
Error Recovery Procedures and Fault Symptom
Codes
N1524A ACL Installation and User’s Guide for the NonStop S-Series Tape Enclosure — 527340-001
C -11
Menu Error Codes
5014
LTO Already Loaded
User has chosen the Clean Drive menu selection,
but a LTO previously determined to be unloaded
and now selected to be cleaned, has indicated the
presence of a tape cartridge.
D, 1, 5
5015
Expired Clean'g Cart
User has chosen the Clean Drive menu selection,
but has specified a slot which contains an expired
cleaning cartridge.
D, 5, 8
5016
Not a Clean'g Cart
User has chosen the Clean Drive menu selection,
but has specified a slot which does not contain a
cleaning cartridge.
D, 5, 8
5017
No Slots Installed
The Clean Drive menu is selected with no
magazine installed.
D, 5
5020
All LTOs/Slots Empty
User has chosen the Map Info menu selection,
but all drive and slot locations are currently devoid
of tape cartridges.
D, 5
5021
Bad Cartridge Map
D, 1
5030
Bad Novram Setting
A setting restored from Novram, which
successfully passed the Novram checksum
verification performed at power-up, nevertheless
was determined to be invalid.
D, 1
5031
Bad Calendar Setting
A time or date setting obtained from the Real
Time Clock, which was indicated as being
"running", nevertheless was determined to be
invalid.
D, 1
5032
Bad Setting
A default setting was determined to be invalid.
D, 1
5033
Set Density Failed
User has chosen the LTO Density menu selection,
but the chosen LTO has failed to successfully
execute the density change request.
D, 3
5034
Set Compression Failed
User has chosen the LTO Compression menu
selection, but the chosen LTO has failed to
successfully execute the compression mode
change request.
D, 3
5035
LTO Timeout Error
Drive communication error during a menu
operation.
D, 3
5036
LTO Timeout Error
Drive communication error during a menu
operation.
D, 3
5037
LTO Set Bus ID Error
Error returned from drive when trying to set a
SCSI ID with the configure menu.
D, 3
5038
SCSI Lock Overrides
Display message only if an attempt is made to
remove a magazine while a Prevent Medium
removal is in effect.
D, 5
FSC
Message
Description
ERP