HP NonStop G-Series - Manual (Page 122)

Error Recovery Procedures and Fault Symptom
Codes
N1524A ACL Installation and User’s Guide for the NonStop S-Series Tape Enclosure — 527340-001
C -10
Power-On Error Codes
Power-On Error Codes
Menu Error Codes
FSC Message Description ERP
4001 Rom CRC Error A, B, 1
4002 Ram Test Failed A, B, 1
4003 Xilinx Progr. Error A, B, 1
4010 Comm. Uart Error A, B, 1
4011 Trace Uart Error A, B, 1
4012 Barcode Uart Error A, B, 1
4013 LTO 1 Uart Error A, B, 1
4014 LTO 2 Uart Error A, B, 1
FSC Message Description ERP
5001 No LTOs Attached User has chosen the Load/Unload menu
selection, but no LTO drives are currently
attached to the Library. D, 5
5002 All LTOs/Slots Empty User has chosen the Load/Unload menu
selection, but all drive and slot locations are
currently devoid of tape cartridges. D, 5
5003 All LTOs/Slots Full User has chosen the Load/Unload menu
selection, but all drive and slot locations are
currently occupied with tape cartridges. D, 5
5004 No Slots Installed The user has chosen the Load/Unload menu, with
no magazine. D, 5
5010 No LTOs Attached User has chosen the Clean Drive menu selection,
but no LTO drives are currently attached to the
Library. D, 5
5011 All Slots Empty User has chosen the Clean Drive menu selection,
but all slot locations are currently devoid of tape
cartridges. D, 5
5012 All LTOs Full User has chosen the Clean Drive menu selection,
but all LTO drive locations are currently occupied
with tape cartridges. D, 5
5013 LTO Timeout Error A LTO, previously determined at boot-up to be
attached, has not responded to a communication
attempt. D, 1, 5