HP Array Controller HSG V8.7 Software - Manual (Page 122)

Single-Ended I/O Module
5–20 UltraSCSI RAID Enclosure
15. On the second expansion enclosure shroud, align the module that has
Cable B (C ALLOUT B) attached with the Port 1 backplane connector.
Gently insert the module and fully seat it. Use a screwdriver to
tighten the spring-loaded mounting screws.
16. Repeat steps 5 through 15 for the remaining SCSI buses (ports 2
through 6).
17. Turn O N the subsystem using Table 5–7 and verify that it is operating
properly.
Table 5–8 Installing Three-Enclosure Subsystem
Cables (Continued)
CXO5841B
6 4 2
5 3 1
6 4 2
5 3 1
6 4 2
5 3 1
A
B