HP Array Controller HSG V8.7 Software User Manual
HP Storage
Advertising
Compaq Computer Corporation
Houston, Texas
Compaq StorageWorks
UltraSCSI RAID Enclosure
(DS–BA370 Series)
User's Guide
Part Number: EK–BA370–UG. C02/387403–001
September 1998
The DS–BA370 series UltraSCSI RAID rack-mountable enclosure is the
basic building block of UltraSCSI RAID subsystems. This guide and its
related publications comprise the basic documentation set for these
subsystems.
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Compaq StorageWorks UltraSCSI RAID Enclosure (DS–BA370 Series)
- Table of Contents
- List of Figures
- List of Tables
- Preface
- Manufacturer’s Declarations
- 1
- 2
- 3
- Environmental Monitoring Unit
- Figure 3–1 EMU
- Product Description
- Configuring the EMU
- Connecting the EMU Communication Bus
- EMU Firmware
- Setting the Temperature Sensors
- Setting the Blower Speed Control
- EMU Status Reporting
- Error Condition Reporting
- Configuration Fault Code Reporting
- Replacing an EMU
- Environmental Monitoring Unit
- 4
- Power Verification and Addressing
- Figure 4–1 PVA
- Figure 4–2 PVA Location
- Product Description
- Functions
- PVA Operation
- Setting the Enclosure Address
- Implementing the Standby Power Mode
- Replacing a PVA
- Power Verification and Addressing
- 5
- Single-Ended I/O Module
- Figure 5–1 Single-Ended I/O Module
- Figure 5–2 I/O Module Location
- Figure 5–3 I/O Module Numbering
- I/O Module and Expansion Cable Error Conditions
- Expanding the UltraSCSI Bus
- Controlling the Internal SCSI Bus
- Controlling the External SCSI Bus
- Controlling the Fault Bus
- Error Reporting
- Rules for Expanding an UltraSCSI Bus
- Cabling an UltraSCSI Subsystem
- Replacing an I/O Module
- Replacing an Expansion Cable
- Single-Ended I/O Module
- 6
- 7
- 8
- Appendix A
- Appendix B
- Assembling an UltraSCSI RAID Subsystem
- Figure B–1 UltraSCSI RAID Subsystem
- Installation Sequence
- Installing the EMU
- Installing the PVA
- Installing the Disk Drive SBBs
- Installing the I/O Modules and Expansion Cables
- Installing Array Controllers and Cache Modules
- Installing the Power System
- Connecting Subsystem Cables
- Configuring the Subsystem
- Assembling an UltraSCSI RAID Subsystem
- Appendix C
- Glossary