HP Array Controller HSG V8.7 Software - Manual (Page 50)

Operating the UltraSCSI Enclosure
2–14 UltraSCSI RAID Enclosure
C ALLOUT 1 is the system OK LED and is green. Callout 2 is the
system fault LED and is amber. One or both of these two LEDs can be
O
N at any time.
When the green system OK LED is O N , it indicates that the enclosure
is operational. This LED can be O N as long as a minimum number of
redundant components (such as blowers or power supplies) are
functioning correctly.
If the amber system fault LED is O N , it indicates one or more
components have an error or fault condition. To isolate an error
condition, observe the status LEDs on the EMU, PVA, power
supplies, disk drive SBBs, and array controllers. These component
status LEDs are discussed under Controller Shelf Status Indicators
later in this chapter. Table 2–7 lists possible enclosure status LED
displays.
Figure 2–3 DS–BA370 Status
LEDs Locations Figure 2–4 RA7000 Status LEDs Locations
C ALLOUTS For Figures
1. System OK LED 2. System fault LED
CXO5751B
1
2
CXO5451C
1 0
1 0
1
2