HP Array Controller HSG V8.7 Software - Manual (Page 175)

Assembling an UltraSCSI RAID Subsystem
UltraSCSI RAID Enclosure B–3
1. Mount an empty UltraSCSI RAID enclosure in the data center
cabinet using cabinet documentation. Departmental server
cabinets arrive prepared for component installation.
2. Install the EMU and the EMU communication cables as required.
3. Install the PVA.
4. Install the disk drive SBBs.
5. Install the I/O modules and UltraSCSI bus cables as required.
6. Install the array controllers and cache modules.
7. Install the ECBs per array controller documentation.
8. Install the power system.
9. Connect subsystem cabling.
10. Configure the subsystem using configuration rules described in
Chapter 2.
Installing the EMU
Each UltraSCSI enclosure requires an EMU for proper operation. In
an expansion configuration, connect an EMU-EMU communication
cable between the master EMU and all expansion EMUs. Complete
the following procedure to install an EMU.
Complete the procedure in Table 3–10, steps 1 through 4, to install an
EMU.
Installing the PVA
Each UltraSCSI enclosure requires a PVA for proper operation.
Complete the procedure in Table 4–7, steps 1 through 4, to install a
PVA.
Installing the Disk Drive SBBs
Install the disk drive SBBs sequentially in the UltraSCSI enclosure
using the procedure in Table 7–4, steps 1, 2, and 8 through 11.