HP Array Controller HSG V8.7 Software - Manual (Page 158)

Storage Devices
7–12 UltraSCSI RAID Enclosure
Table 7–4 Installing a Disk Drive SBB
1. Verify that the disk drive SBB is the
correct model and fill in bezel label
information for this disk drive.
2. If assembling an UltraSCSI enclosure, go to step 8.
3. For a hot or warm swap,
insert the disk drive
SBB into the guide slot
and push it in until the
mounting tabs engage
the shelf, fully seating
the disk drive SBB.
4. After installing the disk
drive SBB during a hot
swap, go to step 14.
5. If performing a warm swap, refer to array controller documentation
to restart the subsystem, then go to step 14.
CXO-4562A-MC
CXO-5338A-MC