HP Array Controller HSG V8.7 Software - Manual (Page 126)

Single-Ended I/O Module
5–24 UltraSCSI RAID Enclosure
Table 5–12 Installing an Expansion Cable
1. Verify that the expansion cable is
the proper type and length per
Table 5–4.
2. Align the cable with the
left I/O module
connector. Gently insert
the cable connector into
the module connector.
Tighten both cable
connector thumb screws
to fully seat the
connector.
3. Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
4. Repeat steps 2 and 3 for the other end of the cable. This end of the
cable might connect to a left or right I/O module connector,
depending on the enclosures involved.
5. Align the I/O module with the backplane connector in the enclosure
shroud. Gently insert the module and fully seat it. Use a screwdriver
to tighten the spring-loaded mounting screws.
6. Turn O N the subsystem and verify that it is operating properly.
CXO5702A
CXO5940A