HP Array Controller HSG V8.7 Software - Manual (Page 187)

Installing EMU Microcode
UltraSCSI RAID Enclosure C–5
Table C–4 Typical PC Monitor Display
Display Text Comments
SW 370 EMU (ROM) Version V01.02
Copyright © 1997, Digital Equipment Corporation
EMU successfully completed
boot.
+++ Attempting to load FLASH image from UART +++
Download Parameters
Raw ASCII, 38400 Baud, 8 data bits, no stop
bits
Communications program
parameters.
Waiting for receiver ready All the EMU blower LEDs are
O
N . Ready to start transfer.
No visible activity for 30 to 60 seconds
+++ Loaded image copied to Upper FLASH +++ Communications program has
uploaded microcode to EMU.
+++ Copying Upper FLASH image to Lower FLASH +++ EMU transferring new
microcode.
+++ Lower FLASH is valid +++
+++ Upper FLASH is valid +++
New microcode verification
complete.
SW370 EMU (Flash) Version 1.1
SW370 EMU Protocol Version 1.0
Copyright © 1997, Digital Equipment Corporation
EMU Hardware Rev 0
EMU initializing.
This is CAB 000
Bus 0 or 1 I/O mod changed, old 0000, new 0002
Bus 2 or 3 I/O mod changed, old 0000, new 0002
Bus 4 or 5 I/O mod changed, old 0000, new 0002
Power OK changed, old 0000, new 0002
Error sum changed, old 0000, new 0002
SubStat 0 changed, old 0000, new 0002
Supplies present change, old 0000, new 0002
All B fans present
All A fans present
Fan OK changed, old 0000, new 0002
Err sum changed, old 0000, new 0002
Power OK changed, old 0000, new 0002
Power OK changed, old 0000, new 0002
Sample EMU status report.