HP SAN Virtualization Services Platform - Manual (Page 50)

Keyword values
[name]
Name of configuration file.
See also
“ Delete config command ” on page 24
“ Load config command ” on page 38
“ Show configs command ” on page 54
Save debug
command
Save the current debug state for all the kernel modules. These values can be restored later using the
load debug
command.
Syntax
save debug
See also
“ Create debug command ” on page 22
“ Load debug command ” on page 38
“ Reset debug command ” on page 47
“ Set debug command ” on page 50
“ Show debug command ” on page 55
“ Watch debug command ” on page 71
Set debug
command
Sets debug values for kernel modules. Used by HP support engineers in debugging a problem. See
examples below for more information.
Syntax
set debug [module-name] level [level value]
set debug [module-name] type [type-list] level [level value]
Keyword values
[module name]
Kernel module where the debug values will be set.
[level value]
New level to be set.
[type-list]
CLI commands 50