HP Color LaserJet CP6015 Printer series User Manual
Page 204
Control panel message
Description
Recommended action
3.
Install or adjust roller unit.
4.
Close the transfer access panel.
5.
Close the right door.
INSTALL SUPPLIES
For status press
(Checkmark button)
Press the checkmark button
to identify
which supplies need replaced.
Insert the supply item or make sure the
installed supply item is fully seated.
INSTALL TRANSFER UNIT
The transfer unit has been removed or
installed incorrectly.
1.
Open right door.
2.
Open transfer access panel. Push locks
upward.
3.
Install or transfer unit.
4.
Close the transfer access panel.
5.
Close the right door.
INSUFFICIENT MEMORY TO LOAD
FONTS/DATA
For help press (Help button)
USB STORAGE <X>
To continue press
(Checkmark
button).
The product does not have enough memory
to load the data (for example, fonts or
macros) from the location specified.
To continue without this information press the
checkmark button
. If the message
persists, add more memory.
INTERNAL DISK DEVICE FAILURE
To clear press
(Checkmark button)
The specified device has failed.
Press the checkmark button
to clear.
INTERNAL DISK FILE OPERATION
FAILED
To clear press
(Checkmark button)
A PJL file system command attempted to
perform an illogical operation.
Press the checkmark button
to clear.
INTERNAL DISK FILE SYSTEM IS FULL
To clear press
(Checkmark button)
A PJL file system command could not store
something on the file system because the file
system was full.
Press the checkmark button
to clear.
INTERNAL DISK IS WRITE PROTECTED
To clear press
(Checkmark button)
The file system device is protected and no
new files can be written to it.
Press the checkmark button
to clear.
INTERNAL DISK NOT FUNCTIONAL
The internal disk is not working correctly.
Turn product off and then on. If the message
persists, contact HP Support at
.
INTERNAL DISK SPINNING UP
The internal disk is spinning up its platter.
Jobs that require disk access must wait.
No action is necessary.
JOB NOT STAPLED DUE TO MIXED SIZES A job sent to the optional paper handling
device was not stapled because it had mixed
sizes of paper.
Resend the job using only one size of paper.
LOAD TRAY 1 [Type] [Size]
For help press (Help button)
This message appears when Tray 1 is
selected but is not loaded, and no other paper
trays are available for use.
Load Tray 1 with requested paper and then
press the checkmark button
to continue.
Table 12-1
Control-panel messages (continued)
190 Chapter 12 Solve problems
ENWW