HP Color LaserJet CP6015 Printer series - Manual (Page 51)

Item Sub-item Values Description
AUTO IP: A link-local IP address 169.254.x.x is set.
LEGACY: The address 192.0.0.192 is set, consistent
with older HP Jetdirect products.
DHCP RELEASE
● NO
● YES
This menu appears if CONFIG METHOD was set to
DHCP and a DHCP lease for the print server exists.
NO*: The current DHCP lease is saved.
YES: The current DHCP lease and the leased IP
address are released.
DHCP RENEW
● NO
● YES
This menu appears if CONFIG METHOD was set to
DHCP and a DHCP lease for the print server exists.
NO*: The print server does not request to renew the
DHCP lease.
YES: The print server requests to renew the current
DHCP lease.
MANUAL SETTINGS
● IP ADDRESS
● SUBNET MASK
● SYSLOG SERVER
● DEFAULT
GATEWAY
● IDLE TIMEOUT
(Available only if CONFIG METHOD is set to
MANUAL) Configure parameters directly from the
printer control panel:
IP ADDRESS: The unique IP address of the printer,
where n is a value from 0 to 255.
SUBNET MASK: The subnet mask for the printer,
where m is a value from 0 to 255.
SYSLOG SERVER: The IP address of the syslog
server used to receive and log syslog messages.
DEFAULT GATEWAY: The IP address of the gateway
or router used for communications with other networks.
IDLE TIMEOUT: The time period, in seconds, after
which an idle TCP print data connection is closed
(default is 270 seconds, 0 disables the timeout).
PRIMARY DNS Specify the IP address (n.n.n.n) of a Primary DNS
Server.
SECONDARY DNS Specify the IP address (n.n.n.n) of a Secondary
Domain Name System (DNS) Server.
IPV6 SETTINGS ENABLE
● OFF
● ON
Use this item to enable or disable IPv6 operation on the
print server.
OFF*: IPv6 is disabled.
ON: IPv6 is enabled.
ADDRESS
● MANUAL
SETTINGS
● ADDRESS
Use this item to manually configure an IPv6 address.
Use the MANUAL SETTINGS menu to enable and
manually configure a TCP/ IPv6 address.
Select ENABLE and choose ON to enable manual
configuration, or OFF to disable manual configuration.
Table 2-1 Embedded Jetdirect and EIO <X> Jetdirect menus (continued)
ENWW Configure device menu 37