Enww control-panel messages 197 – HP Color LaserJet CP6015 Printer series User Manual
Page 211
Control panel message
Description
Recommended action
6.
Close the transfer access panel.
7.
Close the right door.
REPLACE TRANSFER KIT
For help press (Help button)
To continue press
(Checkmark
button)
The REPLACE SUPPLIES menu is set to
STOP AT LOW. The transfer kit has passed
the low threshold.
Press the
to continue printing until the
transfer unit reaches the end of life or replace
transfer kit.
Replace transfer kit.
1.
Open the right door.
2.
Open the transfer access panel.
3.
Push locks upward.
4.
Install transfer unit.
5.
Push locks downward.
6.
Close the transfer access panel.
7.
Close the right door.
Request accepted please wait
The product has accepted a request to print
an internal page, but the current job must
finish printing before the internal page will
print.
No action is necessary.
RESEND EXTERNAL ACCESSORY
FIRMWARE
The product detected corrupt firmware in an
input or output accessory.
Printing can continue from another source or
to another destination, if available. If product
attempts to use a corrupt accessory, there is
a high probability it will jam.
Resend upgrade
The firmware upgrade was not completed
successfully.
Attempt upgrade again.
Restoring
The product is restoring settings. This
message is displayed during the execution of
a restore action, such as RESTORE COLOR
VALUES.
No action is necessary.
Restoring factory settings
The product is restoring factory settings.
No action is necessary.
Restoring... [ACCESSORY #]
The product is restoring external accessory
settings in response to a user request.
No action is necessary.
RFU LOAD ERROR SEND FULL RFU ON
<X> PORT
An error has occurred during a firmware
upgrade.
If the message persists, contact HP Support
ROM DISK DEVICE FAILURE
To clear press
(Checkmark button)
The specified device has failed.
Press the checkmark button
to clear.
ROM DISK FILE OPERATION FAILED
To clear press
(Checkmark button)
A PJL file system command attempted to
perform an illogical operation.
Press the checkmark button
to clear.
ROM DISK FILE SYSTEM IS FULL
To clear press
(Checkmark button)
A PJL file system command could not store
something on the file system because the file
system was full.
Press the checkmark button
to clear.
ROM DISK IS WRITE PROTECTED
To clear press
(Checkmark button)
The file system device is protected and no
new files can be written to it.
Press the checkmark button
to clear.
Table 12-1
Control-panel messages (continued)
ENWW
Control-panel messages 197