HP XP External Storage Software - Manual (Page 126)

8 Troubleshooting
This chapter provides troubleshooting information for XP External Storage.
•
“Troubleshooting for XP External Storage” (page 126)
•
“Calling HP Technical Support” (page 131)
Troubleshooting for XP External Storage
If you have a problem with the Remote Web Console computer or Remote Web Console software,
see the HP StorageWorks XP24000/XP20000 Remote Web Console User Guide for troubleshooting
information.
Table 31 (page 126) provides general troubleshooting instructions for the XP External Storage
operations. If you need to call the HP technical support, see “Calling HP Technical Support”
(page 131) for instructions.
Table 31 General Troubleshooting for XP External Storage
Corrective Action Error
Remove the error and retry the operation.
The reason for the error could be as follows:
•
The switch is off.
• An error occurred in the switch.
•
The cables are not properly connected.
•
Configuration in the external storage system is altered, and the specified
external volume has already been deleted.
•
An error on the external volume in the external storage system has occurred.
•
The path has been changed in the external storage system.
• The port attribute of the local storage system has been changed.
•
The topology information has not been properly set.
The Remote Web Console computer
cannot access the external volume.
Remove the error and retry the operation.
The reason for the error could be as follows:
•
The number of mapped volumes exceeds the maximum number (63,232)
available for the local storage system.
• There are not enough LDKC:CU:LDEV numbers available for external volume
mapping.
The external volume cannot be
mapped as an internal volume of the
local storage system.
1. The factors listed in the first row of Table 31 (page 126) (Error: The Remote
Web Console computer cannot access the external volume) could also be
the reason for this error. Check the factors of the first row, remove the error,
and retry the operation. When the error still remains, try step 2.
2. Try the following procedures. If the following procedures do not work and
the path is not restored, call HP technical support.
• Confirm that the cable between the local storage system and the external
storage system is connected properly.
• When the cable between the local storage system and the external storage
system is connected properly, disconnect it once and connect it
appropriately again. After 30 seconds, check the path status from Remote
Web Console.
The path to the external volume is
blocked.
See “Troubleshooting the Mapping Path” (page 127) and perform the required
action.
The path status that requires the
reaction appears in the Mapping Path
Information dialog box (see
“Mapping
Path Information Dialog Box”
(page 86)
.
126 Troubleshooting