Fujitsu fibrecat cx series, System option mode, Notes on connecting fujitsu fibrecat cx series – HP XP External Storage Software User Manual

Page 151: Sgi is4600 series, Non-hp storage systems

Advertising
background image

Fujitsu FibreCAT CX Series

System Option mode

When you connect a Fujitsu FibreCAT CX series as an external storage system, set system option
mode 725 of the local storage system. If system option mode 725 is not set, the external storage
system might be blocked when performing maintenance, including rebooting the controller of the
external storage system by the firmware update and so on. For instructions about setting system
option mode 725, contact

System Parameter for Connecting Fujitsu FibreCAT CX Series

When you connect a Fujitsu FibreCAT CX series as an external storage system, set the system
parameters of the Fujitsu FibreCAT CX series according to the following table. For the system
parameters that are not in the following table, refer to the documentation of the Fujitsu FibreCAT
CX series and set the parameters appropriately for the connecting configuration.

Table 58 System Parameters for Connecting Fujitsu FibreCAT CX Series

Parameter Setting

Parameter

CLARiiON Open

Initiator Type

2

Failover Mode

Notes on Connecting Fujitsu FibreCAT CX Series

Volumes created with the RAID0 level or Individual Disk Units (JBOD disks) of Fujitsu FibreCAT CX
series are not supported.

SGI IS4600 Series

When connecting an SGI IS4600 series as an external storage system, set the system parameters
of the SGI IS4600 series according to the following table. For system parameters that are not in
the following table, refer to the documentation of the SGI IS4600 series and set the parameters
appropriately for the connecting configuration.

Table 59 SGI IS4600 Series

Parameter Setting

Parameter

When alternate paths are connected to different clusters
on the SGI IS4600 series side: Linux

host type

Non-HP Storage Systems

Generally, when connecting a non-HP storage system as the external storage system, the non-HP
storage system port must be configured as a target attached to a Windows host. The third-party
vendor should be contacted as necessary for the technical details to accomplish this.

Fujitsu FibreCAT CX Series

151

Advertising
This manual is related to the following products: