HP XP External Storage Software - Manual (Page 87)

Table 12 Status of the Mapping Paths in the Mapping Path Information Dialog Box
(continued)
Description Displayed Item
The setting of the external storage system has been changed. For example, the
path definition was deleted, or the external storage system itself was replaced
by another device. External device
setting changed
The setting of the volume capacity of the external storage system has been
changed (the volume capacity was reduced). LDEV size reduced
The reply from the external storage system was NOT READY. Not ready
The reply from the external storage system was ILLEGAL REQUEST. Illegal request
The reply from the external storage system was ABORTED COMMAND. Command aborted
The external storage system is busy. Busy
The external storage system is reserved. LDEV reserved
The external storage system is blocked due to an abnormal reply. Response error
The port attribute of the external storage system has been changed to the initiator
port. Initiator port
The port attribute of the external storage system is unknown. Unknown port
The path has been removed or the port of the external storage system cannot be
found. Cannot detect port
The program error occurred or there is a logical contradiction. Internal error
Processing was retried because an abnormal reply was returned, however, the
processing has timed out. Timeout
The port of the external storage system is not active. The port status is normal but
the port is not used for I/O. Passive
The port of the external storage system is standing by. The port status is normal
but cannot receive I/O. Standby
Port failures, such as controller blockade, are detected on the external storage
system side. Target error
The process of checking the mapping path status is in progress. Checking
Connection to the external storage system or the external volume is intentionally
stopped using the Disconnect Subsystem command or the Disconnect Volume
command. Disconnect
The reply from the external storage system was Unavailable. The external storage
system demands to change the connected port. Once the status becomes
Unavailable, the primary path is changed to the alternate path that is in the
Standby status. When the primary path changes, the status of the path becomes
Normal. Unavailable
The reply from the external storage system was Backoff. The status of the path is
waiting for recovery because a temporary error has occurred in the volume of
the external storage system. Even if the status of the primary path becomes this
status, the primary path is not changed to the alternate path immediately. After
the error recovery, the status becomes Normal. If the status cannot be recovered
from the error, the path status is changed to the other status. Backoff
An external volume is mapped, but you cannot access the volume in the external
storage system. Device check error
The volume in the external storage system becomes inaccessible. Medium error
Checking the External Volume Details 87