HP XP External Storage Software - Manual (Page 124)

Figure 43 Example of Using XP Continuous Access or XP Continuous Access Journal with Remote
Command Device
Procedure to Use Initiator/External MIX Mode
This section describes the procedure to use the Initiator/External MIX mode and the procedure to
stop using the Initiator/External MIX mode.
To use the Initiator/External MIX mode:
1. Prepare the initiator ports of the Standard mode and external ports of the Standard mode in
one port block.
For the procedure to set the port attribute to initiator, see the HP StorageWorks
XP24000/XP20000 Continuous Access Software User's Guide or the HP StorageWorks
XP24000/XP20000 Continuous Access Journal Software User Guide.
2. Set the Initiator/External MIX mode to the port block consisting of the initiator ports of the
Standard mode and external ports of the Standard mode.
For the procedure to set the Initiator/External MIX mode, see the HP StorageWorks
XP24000/XP20000 LUN Manager User Guide.
3. Connect the cable to the port, and connect a storage system to be used as an MCU and local
storage system and a storage system to be used as an RCU and external storage system.
124 Remote Command Devices