HP XP External Storage Software - Manual (Page 162)

-1: An error occurred.
If multiple external volumes are specified, 0 returns only when all the commands on all the external
volumes are finished successfully. When the checkstatus command is executed, different termination
codes will return.
An error (the termination code -1) occurs under the following conditions:
•
When a command file contains information about an external volume that does not exist.
When the disconnect or checkpath command is executed, the RMI server error (605, 5828)
occurs. When the checkstatus command is executed, the error "Unable to use the external
volume group" occurs.
•
When the ExPath tool is executed for a storage system other than an HP XP24000/XP20000
Disk Array.
•
When the version of the ExPath tool and the version of the storage system microcode do not
match.
Command Reference
You can write commands for the ExPath tool in a command file. The commands that can be written
are:
Table 63 Command List for the ExPath Tool
Description Purpose Command
Specifies the IP address of the SVP. For authentication. Required when no
authentication file is used. svpip
Specifies the login user ID and the
password. login
Specifies the login user ID and the
password. For external volume operations. Only
one of these commands can be written
in one file. disconnect
Specifies the login user ID and the
password. checkpath
Retrieves external volume statuses. checkstatus
svpip Command
Syntax
svpip ip-address
Description
Specifies the IP address of the SVP. When the SVP has an IPv6 address, do not write this command
in a command file. Create an authentication file instead. If you specify an authentication file when
you run the ExPath tool, this command will be ignored.
Parameters
Description Parameter
Specifies the IPv4 address of the SVP. ip-address
Example
The following example specifies 158.214.127.170 as the IP address of the SVP:
svpip 158.214.127.170
162 The ExPath Tool