HP EML E-series Tape Libraries User Manual
HP Storage
Advertising
Table of contents
Document Outline
- Contents
- About this guide
- 1 Library overview
- 2 Using the library
- Powering on the library
- Powering off the library
- Center-door interlock
- Doing an inventory
- Attaching bar code labels to tape cartridges
- Setting the write-protect switch
- Inserting tape cartridges into the load port
- Using the OCP
- Controls and indicators
- Library robotics controller
- HP StorageWorks Interface Manager card
- HP StorageWorks e2400-FC 2Gb interface controller
- HP StorageWorks e2400-FC 4Gb interface controller
- HP StorageWorks Ultrium tape drives
- Switch for the internal network
- Library main power switch
- Power supply in the base module or tape drive expansion module
- Power supply in the card cage expansion module
- Power distribution unit
- 3 Maintaining the library
- 4 Removing and replacing parts
- Library robotics controller
- HP StorageWorks Interface Manager card
- CompactFlash memory card
- HP StorageWorks e2400-FC 2Gb interface controller
- HP StorageWorks e2400-FC 4Gb interface controller
- Power supply in the base module or tape drive expansion module
- Power supply in the card cage expansion module
- LTO2 or LTO3 tape drive
- LTO4 tape drive
- Load port magazine
- 5 Moving the library
- A Specifications and characteristics
- B Regulatory compliance notices
- C Ordering HP tape cartridges and bar code label packs
- D Installing a redundant PDU
- Glossary
- Index