HP Officejet J5740 All-in-One Printer - Manual (Page 113)

To remove numbers from the list of junk fax numbers
1. Press Setup.
2. Press 4, and then press 7.
This selects Basic Fax Setup and then selects Junk Fax Blocker Set Up.
3. Press 2.
This selects Remove Number from Junk List.
4. Press to scroll through the numbers you have blocked. When the number you want
to remove appears, press OK to select it.
5. When the Delete Another? prompt appears, do one of the following:
•
If you want to remove another number from the list of junk fax numbers,
press 1 to select Yes, and then repeat step 4 for each number you want to block.
• If you are done, press 2 to select No.
Fax over the Internet using IP phone
You might subscribe to a low-cost phone service that allows you to send and receive
faxes with the HP All-in-One by using the Internet. This method is called Fax over Internet
Protocol (FoIP). You probably use a FoIP service (provided by your telephone company)
if you:
• Dial a special access code along with the fax number, or
• Have an IP converter box that connects to the Internet and provides analog phone
ports for the fax connection.
NOTE: You can only send and receive faxes by connecting a phone cord to the 1-
LINE port on the back of the HP All-in-One. This means that your connection to the
Internet must be done either through a converter box (which supplies regular analog
phone jacks for fax connections) or your telephone company.
The FoIP service might not work properly when the HP All-in-One is sending and receiving
faxes at high speed (33600 bps). If you experience problems sending and receiving faxes,
use a slower fax speed. You can do this by changing the Fax Speed setting from Fast
(the default) to Medium.
You should also check with your telephone company to make sure their Internet phone
service supports faxing. If they do not support faxing, you might encounter intermittent
problems when trying to send and receive faxes through the Internet.
Related topics
Set the fax speed
Print reports
You can set up the HP All-in-One to print error reports and confirmation reports
automatically for each fax you send and receive. You can also manually print system
reports as you need them; these reports provide useful system information about the
HP All-in-One.
By default, the HP All-in-One is set to print a report only if there is a problem with sending
or receiving a fax. A confirmation message that indicates whether a fax was successfully
sent appears briefly on the display after each transaction.
Fax over the Internet using IP phone 111