Set up the hp all-in-one for faxing – HP Officejet J5740 All-in-One Printer User Manual

Page 26

Advertising
background image

TIP:

You can also use the Fax Setup Wizard (Windows) or Fax Setup Utility (Mac)

to help you quickly set up some important fax settings such as the answer mode and
fax header information. You can access the Fax Setup Wizard (Windows) or Fax
Setup Utility
(Mac) through the software you installed with the HP All-in-One. After
you run the Fax Setup Wizard (Windows) or Fax Setup Utility (Mac), follow the
procedures in this section to complete your fax setup.

This section contains the following topics:

Set up the HP All-in-One for faxing

Change settings on the HP All-in-One to receive faxes

Test your fax setup

Set the fax header

Set up speed dialing

Set up the phone book

Set up the HP All-in-One for faxing

Before you begin setting up the HP All-in-One for faxing, determine which kind of phone
system your country/region uses. The instructions for setting up the HP All-in-One for
faxing differ depending on whether you have a serial- or parallel-type phone system.

If you do not see your country/region listed in the table below, you probably have a
serial-type phone system. In a serial-type phone system, the connector type on your
shared telephone equipment (modems, phones, and answering machines) does not
allow a physical connection to the "2-EXT" port on the HP All-in-One. Instead, all
equipment must be connected at the telephone wall jack.

NOTE:

In some countries/regions that use serial-type phone systems, the phone

cord that came with the HP All-in-One might have an additional wall plug attached
to it. This enables you to connect other telecom devices to the wall jack where
you plug in the HP All-in-One.

If your country/region is listed in the table below, you probably have a parallel-type
telephone system. In a parallel-type phone system, you are able to connect shared
telephone equipment to the phone line by using the "2-EXT" port on the back of the
HP All-in-One.

NOTE:

If you have a parallel-type phone system, HP recommends you use the

2-wire phone cord supplied with the HP All-in-One to connect the HP All-in-One
to the telephone wall jack.

Table 4-1 Countries/regions with a parallel-type phone system

Argentina

Australia

Brazil

Canada

Chile

China

Colombia

Greece

India

Indonesia

Ireland

Japan

Korea

Latin America

Malaysia

Chapter 4

24

Finish setting up the HP All-in-One

Advertising