HP Hitachi Dynamic Link Manager Software - Manual (Page 235)

Figure 3-14 Example of Editing /etc/elilo.conf file
Edit the shaded portion.
17
.
If necessary, back up the file.
18
.
Copy the configuration that was used for startup from the SCSI device.
19
.
Assign a name to the copied configuration that indicates that the
configuration is used for specifying the HDLM device.
¢
If you will use GRUB as the boot loader
Change title.
¢
If you will use ELILO as the boot loader
Change label.
20
.
Edit the specification for root written in the boot loader configuration file.
From the following, perform the procedure that corresponds to the host
OS.
¢
For Red Hat Enterprise Linux 6:
Specify a root device name or UUID for root.
To specify a root device name for root:
a
.
Execute the mount command to check the root device name.
Below is an example of executing the command. The underlined
part is the root device name.
# mount
/dev/mapper/systemvg-rootlv on / type ext4 (rw)
proc on /proc type proc (rw)
:
:
b
.
Change the root specification contained in the configuration that
you copied in step 18 to the root device name checked above.
Creating an HDLM Environment
3-163
Hitachi Dynamic Link Manager User Guide for Linux ®