HP Hitachi Dynamic Link Manager Software - Manual (Page 247)

¢
Execution example of the command when GRUB as the boot loader is
used
# rm /boot/initrd-hdlm-2.6.9-11.EL.gz
¢
Execution example of the command when IPF (with ELILO as the boot
loader) is used
# rm /boot/efi/efi/redhat/initrd-hdlm-2.6.9-11.EL.gz
26
.
Edit the /etc/fstab file.
Change the /boot mount point that you changed in step 4 from the SCSI
device to the HDLM device. Comment out the existing SCSI device
specification by placing a hash mark (#) at the beginning of each line, and
then add the HDLM device specification as shown below, based on the
correspondence between the HDLM device and the SCSI device as
checked in step 22.
:
:
#/dev/sda1 /boot ext3 defaults 1 2
/dev/sddlmaa1 /boot ext3 defaults 1 2
:
:
This example assumes that IA32 uses GRUB as the boot loader. When you
use IPF that uses ELILO as the boot loader, the mount point is displayed
as /boot/efi instead of /boot in the line where /boot is coded, and the
file system type is displayed as vfat instead of ext3.
27
.
Edit the boot loader configuration file so that the OS will start with HDLM
specified.
Edit the boot loader configuration file as shown in
Figure 3-20 Example of
Editing /etc/grub.conf file on page 3-176 , Figure 3-21 Example of
Editing /boot/grub/menu.lst file (When using a kernel that supports Xen)
on page 3-176 , and Figure 3-22 Example of Editing /etc/elilo.conf file on
page 3-177 .
If you are using SUSE LINUX Enterprise Server, check the /boot/grub/
menu.lst file instead of the /etc/grub.conf file.
Examples of editing the configuration file are shown below. See the
example for the boot loader you are using.
The detailed procedure is explained in steps 28 to 32.
Creating an HDLM Environment
3-175
Hitachi Dynamic Link Manager User Guide for Linux ®