HP Hitachi Dynamic Link Manager Software - Manual (Page 356)

# /etc/init.d/DLMManager stop
Stopping DLMManager: [ OK ]
Lower case characters can be used for the command name (dlmmanager).
# /etc/init.d/dlmmanager stop
Stopping DLMManager: [ OK ]
The stop script that was set up during HDLM installation runs, and stops the
HDLM manager.
Use one of the following procedures to confirm that the HDLM manager has
stopped:
Use the dlnkmgr command's view operation:
Execute the following command.
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -msrv
HDLM Manager Ver WakeupTime
Dead
KAPL01001-I The HDLM command completed normally. operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
#
When the HDLM Manager column shows Dead, the HDLM manager is
inactive.
Use a script for confirmation:
Execute the following command to confirm that the HDLM manager is
inactive:
# /etc/init.d/DLMManager status
Stopping DLMManager: [ OK ]
Note
If an error occurs, the execution results of the dlnkmgr command's view
operation might be different from those of the DLMManager status
command. In this case, see the execution results of the dlnkmgr
command.
HDLM Resident Processes
The table below lists and describes the resident processes in HDLM. To
monitor these processes, use the names below.
Table 4-2 HDLM resident processes
Process Description
.dlmmgr_exe HDLM manager process
4-24
HDLM Operation
Hitachi Dynamic Link Manager User Guide for Linux ®