HP IP Distance Gateway - Manual (Page 101)

Show FcipRoutes command
Shows FCIP route configuration parameters.
None Authority
show fciproutes Syntax
[link_id]
Sets the number of the FCIP route to be displayed (1 or 2)
Parameter
The following is an example of the show fciproutes command: Example
mpx239 (admin) #> show fciproutes
FCIP Route Information
------------------------ FCIP Route 1
FCIP Interfaces Status Enabled
FCIP Link Status Up
FC Port FC1
GE Port GE1
GE Link Status Up
Local IP Address 44.44.1.239
Remote IP Address 44.44.1.240
Subnet Mask 255.255.0.0
Gateway IP Address 0.0.0.0
MTU Size Normal
TCP Window Size 32768
Window Scaling Enabled
Window Scaling Factor 7
TCP Port No 3225
Current GE Port Speed 1Gb/FDX
Programmed GE Port Speed Auto
Bandwidth, Mbit/sec 155 VLAN Disabled FCIP SW
Compression Disabled
FCIP Route 2
FCIP Interfaces Status Enabled
FCIP Link Status Up
FC Port FC2
GE Port GE2
GE Link Status Up
IPv6 Address 1 2000:33::32:2:239
IPv6 Link Local fe80::2c0:ddff:fe0d:b27b
IPv6 Remote Address 2000:33::32:2:240 MTU Size Normal
TCP Window Size 32768
Window Scaling Enabled
Window Scaling Factor 7
TCP Port No 3225
Current GE Port Speed 1Gb/FDX
Programmed GE Port Speed Auto
Bandwidth, Mbit/sec 155
VLAN Disabled
FCIP SW Compression Disabled
mpx239 (admin) #>
Commands 101