Fibre channel driver – HP IP Distance Gateway User Manual
Page 125
Table 27 iSCSI driver—Error log messages (continued)
Description
No.
Log message
ID
The driver failed to receive a
heartbeat from the iSCSI
928
#%d: QLReadyTimer: Adapter missed heartbeat for %d seconds.
Time left %d
74656
processor for the specified
number of seconds.
Driver did not receive a heartbeat
event from iScsi FW
931
#%d: QLReadyTimer: Adapter missed heartbeat for 0x%x seconds
74659
The driver timed out an iSCSI
processor operation and is
aborting the operation.
933
#%d: QLTimer: Abort pTpb=%p, Type %x, Timeout 0x%x
DrvCount 0x%x, DdbIndex 0x%x
74661
The driver timed out an iSCSI
processor mailbox command.
935
#%d: QLReadyTimer: MBOX_CMD %04x %04x %04x %04x
%04x %04x %04x %04x timed out
74663
The driver timed out while
attempting to reconnect with the
iSNS.
937
#%d: QLReadyTimer: QLiSNSReenable failed
74665
Driver detected an error that
requires iSCSI FW to be restarted
977
#%d: QLProcessSystemError: Restart RISC
74705
iScsi FW failed to initialize
1018
#%d: QLInitializeFW: MBOX_CMD_INITIALIZE_FIRMWARE failed
%04x %04x %04x %04x %04x %04x
74746
The driver’s initiator database is
full. The driver is capable of
1056
#%d: QLUpdateInitiatorData: No more room in Initiator Database
74784
storing 1024 iSCSI initiators in
its database. Use the CLI or GUI
to remove unwanted/unused
iSCSI initiators.
The driver’s target database is
full. Use the CLI or GUI to remove
unwanted/unused iSCSI targets.
1072
#%d: QLSetTargetData: No more room in Target Database
74800
Fibre Channel driver
lists error log messages common to both Fibre Channel ports, 1 (FC1) and 2
(FC2). Log messages beginning with #0 apply to Fibre Channel port 1 (FC1), and log messages
beginning with #1 apply to Fibre Channel port 2 (FC2).
Table 28 FC driver—Error log messages
Description
No.
Log message
ID
The FC processor received a
SCSI command for an unknown
87
#%d: QLUtmReceiveIo: Path invalid/FW No resource count
%x
106583
target path or has run out of
resources to execute additional
commands.
The FC processor was disabled
by an IOCTL request to the
driver.
93
#%d: QLIoctlEnable: Adapter disabled
106589
The FC processor firmware
failed initialization. The request
94
#%d: QLIoctlEnable: Initialize FW error
106590
to initialize was received by the
driver in an IOCTL request.
The FC processor failed the
external loopback test.
96
#%d: QLIoctlRunDiag: Diagnostic loopback command failed
%x %x %x %x
106592
Error log messages
125