HP IP Distance Gateway - Manual (Page 72)

3. (Optional) Configure the following port route/parameters:
•
FCIP Interfaces FC & GE—Provides a dialog box for enabling and disabling the FCIP
route. When the route is disabled the FC and GE ports are placed in a down state: all
route configuration parameters are retained.
•
GigE Port Programmed Port Speed—Provides a dialog box that contains four options for
the GigE port speed: Auto, 10, 100, and 1000. The default port speed is Auto.
•
Port Speed Mode—Provides a dialog box that contains three options for the port speed
mode: Auto, Half duplex, and Full duplex. This dialog box is available only when the
GigE port speed is set to something other than Auto.
•
GigE Port Flow Control—Provides a dialog box for enabling and disabling GigE port
flow control. The default is enabled. This dialog box is available only when the GigE port
speed is set to something other than Auto.
4. After selecting a port pair and setting GE port parameters, click Next to continue or Cancel
to exit the wizard.
5. Enter the IP addresses ( Figure 50 (page 72) ).
Figure 50 FCIP Routes Add Wizard—Local and Remote IP Address dialog box
6. Click Next to continue. Otherwise, click Cancel to exit the wizard.
7. Select either the IPv4 Address or IPv6 Address radio button.
IPv4 parameters include:
•
Local IP Address—The IP address to be used by the GigE port. An uninitialized port has
an IP address of all zeros.
•
Subnet Mask —The subnet mask used by the GigE port.
•
Gateway IP Address—The gateway IP address used by the GigE port.
•
Remote IP Address—The IP address of the GigE port on the remote gateway.
72 Using the HP mpx Manager utility