HP IP Distance Gateway User Manual
Page 73
IPv6 parameters include:
•
Local IPv6 Address—The IP address assigned to the GigE port. An uninitialized port has
an IP address of “::”.
•
IPv6 Default Router—The IP address assigned to the GigE port for the default IPv6 router.
An uninitialized port has an IP address of “::”.
•
IPv6 Local Link—The IP address assigned to the Local Link port. This address is
automatically configured and is based on the GigE port MAC address. An uninitialized
port has an IP address of “::”.
•
Remote IPv6 Address—The IP address assigned to the GigE port on the remote gateway.
An uninitialized port has an IP address of “::”.
8.
Enter the TCP/IP parameters in the TCP/IP Options dialog box (
).
Figure 51 FCIP Routes Add Wizard—TCIP/IP Options dialog box
Use the TCP/IP Options dialog box to configure the following parameters:
•
Jumbo Frames—Provides a dialog box for enabling and disabling Jumbo IP frames. When
disabled, the MTU is 1,500 bytes; when enabled, the maximum MTU is 9,000 bytes.
When other is selected, the MTU size can be configured between 1,000 and 9,000
bytes.
•
TCP Window Size—Contains a dialog box that provides three options for TCP window
size: 8,192, 16,384, and 32,768 bytes. The default is 32,768.
•
Window Scaling—Contains a dialog box that provides for enabling and disabling TCP
window scaling. The default is Disabled. When enabled, the Window Scaling Factor
is used.
•
Window Scaling Factor—Contains a dialog box that provides eight options for TCP
window scaling: 0, 1, 2, 3, 4, 5, 6, and 7
•
VLAN Enabled—Provides a dialog box for enabling and disabling VLAN support. The
default is Disabled.
Using wizards
73