HP IP Distance Gateway - Manual (Page 94)

Save command
Saves logs and traces.
Admin session Authority
save Syntax
capture
Creates a debug file that captures all debug dump data. After the command completes,
you must FTP the debug capture file from the mpx110.
Parameters
logs
Creates a .tar file containing the mpx110’s log data, storing the file in the mpx110's
/var/ftp
directory. The operator must then FTP the logs .tar file from the mpx110.
traces
Creates a .tar file containing the mpx110’s dump data storing the .tar file in the
mpx110’s /var/ftp directory. The operator must then FTP the trace's .tar file from
the mpx110. If the mpx110 does not have any dump data, the operator will be notified
when executing this command. An event log entry is generated whenever a data dump
is generated.
The following is an example of the save capture command: Examples
mpx110 (admin) #> save capture
Debug capture completed. Package is System_Capture.
tar.gz Please use FTP to extract the file out from
the System.
The following is an example of the save logs command:
mpx110 (admin) #> save logs
Save Event Logs completed. Package is System_Evl.tar.gz
Please use FTP to extract the file out from the System.
The following is an example of the save traces command:
mpx110 (admin) #> save tracesSave ASIC Traces completed. Package
is System_Asic_Trace.tar.gz. Please use FTP to extract the file
out from the System.mpx110 (admin) #> save tracesNo ASIC trace
files exist to save. Command aborted.
Set command
Configures general parameters, as well as parameters for the FC, iSCSI, and management ports.
Admin session Authority
set Syntax
chap
Sets CHAP secrets
Parameters
mgmt
Sets management port parameters
ntp
Sets NTP parameters
properties
Sets CLI properties
snmp
Sets SNMP parameters
system
Sets system parameters
The following is an example of the set command: Example
mpx110 #>set mgmt
94 Command-line interface