HP IP Distance Gateway User Manual
Page 38
See
Diagnostics and troubleshooting (page 48)
for a description of the LED fault indications.
4.
Telnet to the mpx110 using IP address 1.0.0.1, or use a terminal emulation program (serial
cable) from your workstation (see
):
a.
Enter guest at the login prompt.
b.
Enter password at the password prompt.
NOTE:
HP recommends changing the mpx110 guest password after logging in.
Figure 19 Setting IP addressing using Telnet
5.
Enter admin start at the mpx110 prompt.
6.
Enter the default password, config.
NOTE:
HP recommends that you change the mpx110 Admin password after logging in.
7.
Enter the command set mgmt to set initial parameters.
8.
Follow the on-screen prompts to define the following parameters (or press Enter to accept
default parameters):
•
Mode (HP highly recommends using static address, Option 0)
•
IPv4/IPv6 address (Because the FCIP ports require dedicated bandwidth, HP recommends
that the IP address for the management port be in a different subnet than the FCIP ports.)
•
Subnet mask
•
Default gateway or router
The management port is now configured with the appropriate IP address and network
parameters.
IMPORTANT:
At this point, the Telnet session terminates. To restart the Telnet session, use
the IP address you just assigned to the management port.
38
Installation and upgrades