HP IP Distance Gateway - Manual (Page 111)

Show VLAN command
Displays the mpx110’s VLAN configuration.
None Authority
show vlan [<port_num>] Syntax
port_num
Specifies the iSCSI port number whose VLAN configuration is to be displayed
Parameter
The following is an example of the show vlan command: Example
mpx110 #> show vlan
VLAN Information
------------------
Port 1
VLAN Disabled
ID 0
Priority 0
Port 2
VLAN Disabled
ID 0
Priority 0
mpx110 #> show vlan 1
VLAN Information ------------------
Port 1
VLAN Disabled
ID 0
Priority 0
Shutdown command
Provides for an orderly shutdown of mpx110 firmware. This command does not power down the
mpx110.
Admin session Authority
shutdown Syntax
The following is an example of the shutdown command: Example
mpx110 (admin) #>shutdown
Target command
Removes targets from the mpx110 database. This command is typically used to remove targets
that are no longer connected to the mpx110.
NOTE: The target add command is not currently supported.
Admin session Authority
target Syntax
rm Parameter
Removes a target from the mpx110 target database
The following is an example of the target rm command: Example
mpx110 (admin) #> target rm
Index (WWNN,WWPN/iSCSI Name)
---------------------------
0 20:00:00:20:37:fd:8b:ab:00:00:00:00:fc:b6:1f:fa
Please select an 'OFFLINE' Target from the list above
('q' to quit): q Command aborted.
Commands 111