Restoring the mpx110 configuration, Restoring the configuration using the mpx110 gui, Restoring the configuration using the mpx110 cli – HP IP Distance Gateway User Manual
Page 144
6.
Enter the following command to set the FTP transfer type to binary:
ftp> bin
7.
Enter the following command to retrieve the HP_StorageWorks_mpx110_FRU.bin file:
ftp> get HP_StorageWorks_mpx110_FRU.bin
Restoring the mpx110 configuration
Use the Full Configuration Restore option to fully restore the mpx110 configuration. The restored
configuration takes effect after the mpx110 is rebooted.
NOTE:
Always use the Full Configuration Restore option with the mpx110.
Restoring the configuration using the mpx110 GUI
To restore the configuration using the mpx110 GUI:
1.
Select File > Restore FRU.
The Restore FRU dialog box appears.
2.
Click Browse and select the appropriate file name to restore.
3.
Select Full Configuration Restore or Partial Restore (Mappings).
4.
Click Start.
The Security Check dialog box appears.
5.
Enter the password config, and then click OK.
6.
Reboot the system for the configuration to take effect.
Restoring the configuration using the mpx110 CLI
To restore the configuration using the mpx110 CLI:
1.
Establish an FTP connection to the mpx110 management port and login:
Username: ftp
Password: ftp
2.
Enter the following command to set the FTP transfer type to binary:
ftp> bin
3.
Enter the following command to move the HP_StorageWorks_mpx110_FRU.bin file onto
the FTP:
ftp> put HP_StorageWorks_mpx110_FRU.bin
4.
Log in to the mpx110 using a Telnet session to the management port or console port:
Username: guest
Password: password
5.
Enter the following command:
mpx110> admin start
6.
Enter config as the password.
7.
Enter the following command:
mpx110 (admin) #> fru restore
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value. If you wish to terminate this process before reaching the
end of the list press 'q' or 'Q' and the ENTER key to do so. Type
of restore (0=full, 1=mappings only) [full]
FRU restore completed.
8.
Reboot the system for the configuration to take effect.
144 Saving and restoring the mpx110 configuration