HP IP Distance Gateway - Manual (Page 145)

E Regulatory compliance and safety
This appendix contains regulatory compliance and safety information for the mpx110.
Regulatory compliance
Federal Communications Commission notice for Class A equipment
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which
case the user will be required to correct the interference at his own expense. The end user of this
product should be aware that any changes or modifications made to this equipment without the
approval of Hewlett-Packard could result in the product not meeting the Class A limits, in which
case the FCC could void the user’s authority to operate the equipment.
Declaration of conformity for products marked with the FCC logo, United States only
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
For questions regarding your product, visit
http://www.hp.com/ .
For questions regarding this FCC declaration, contact us by mail or telephone:
•
Hewlett-Packard Company
P.O. Box 692000, Mailstop 510101
Houston, TX 77269–2000
•
1–281–514–3333
To identify this product, refer to the part, Regulatory Model Number, or product number found on
the product.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device
that are not expressly approved by Hewlett-Packard Company my void the user’s authority to
operate the equipment.
Cables
Connections to this device must be made with shielded cables with metallic RFI/EMI connector
hoods in order to maintain compliance with FCC Rules and Regulations.
Regulatory compliance identification numbers
For the purpose of regulatory compliance certifications and identification, your product has been
assigned a unique Regulatory Model Number. The RMN can be found on the product nameplate
label, along with all required approval markings and information. When requesting compliance
information for this product, always refer to this RMN. The Regulatory Model Number should not
be confused with the marketing name or model number of the product.
Laser device
All HP systems equipped with a laser device comply with safety standards, including IEC 825.
With specific regard to the laser, the equipment complies with laser product performance standards
set by government agencies as a Class 1 laser product. The product does not emit hazardous light.
Regulatory compliance 145