HP IP Distance Gateway - Manual (Page 84)

Admin command
Opens and closes the Admin session, which provides commands that change mpx110
configurations. Only one Admin session can be open on the mpx110 at any time. An inactive
Admin session times out after 15 minutes.
Admin session Authority
admin Syntax
start or begin
Opens the Admin session.
Parameters
end or stop
Closes the Admin session. The logout, shutdown, and reset
commands will end an Admin session.
cancel
Terminates an Admin session opened by another user. Use this parameter
with care because it terminates the Admin session without warning the
other users and without saving pending changes.
Closing a Telnet window during an Admin session does not release the
session. In this case, you must either wait for the Admin session to time
out, or use the admin cancel command. Notes
The following example shows how to start and end an Admin session: Example
mpx110 #> admin start
Password: ******
mpx110 (admin) #>
.
.
.
mpx110 #> admin end
mpx110 #>
84 Command-line interface