HP IP Distance Gateway - Manual (Page 95)

Set FC command
Configures an FC port.
Admin session Authority
set fc [port_num] Syntax
port_num
Sets the number of the FC port to be configured
Parameter
The following is an example of the set fc command: Example
mpx239 (admin) #> set fc 1
A list of attributes with formatting and current values
will follow. Enter a new value or simply press the ENTER key
to accept the current value.
If you wish to terminate this process before reaching
the end of the list press 'q' or 'Q' and the ENTER key
to do so.
WARNING:
The following command might cause a loss of connections
to both ports.Configuring FC Port: 1
-------------------------
Port Status (0=Enable, 1=Disable) [Enabled]
Link Rate (0=Auto, 1=1Gb, 2=2Gb) [Auto]
Frame Size (0=512B, 1=1024B, 2=2048B) [2048]
Execution Throttle (Min=16, Max=256) [64]
All attribute values for Port 1 that have been changed will now
be saved.
mpx239 (admin) #>
Commands 95